Wireless system for IP cameras HD and UHD 5,1-5,8 GHz with SMA connector for external antennas
Date of renovation: 2017-04-11
CDS-5IPmini/SMA is a version of CDS-5IPmini designed for use only with external antenna. The range of the system is up to 1-3 km (depending on used antennas).
The system works great with additional external antenna MIMO AK-28 HV (with an RP-SMA). Depending on your needs, you can also use additional omnidirectional antennas AP-13 HV.
High resolution and picture quality
CDS-5IPmini/SMA is a system that transmits the image and sound at a frequency of 5,1 - 5,8 GHz with power 1W (30 dBi). The product is intended for use in wireless IP video surveillance with cameras with Ethernet interface (internal and external). Supports IP cameras with high resolution (up to 10 MPx - 4K UHD).
A special system with protocols for the transmission of HD video and 4k
CDS-5IPmini/SMA is not a computer device to transmit Internet but transmitter for continuous and uninterrupted transmission of heavy HD images. Implemented special protocols audio / video provide broadcasts of all the frames HD and 4k with no delay in transmission. In addition to the simultaneous transmission of multiple images and sounds it also allows you to control PTZ cameras and the data transfer between the recorder and cameras.
CDS-5IPmini/SMA is equipped with software that provides stable transmission. The used multimedia protocols iCAMSAT also make it possible to obtain accurate bitrate measurements from several cameras separately.
The device has the ability to adapt to your system configuration by setting the recommended mode BRIDGE. This ensures high performance and connectivity.
Security of transmission is ensured by the use of 64/128 -bit and other security codes. The system also has the capability of remote configuration. Blocking the access and use of router protects the cameras from the rest of the network.
Small and universal
The small size and aesthetic appearance enhance the usability and enable their use even in prestigious places. The device is barely visible on the facade.
CDS-5IPmini has a hermetic casing, which makes the devices resistant to even the most severe weather conditions. The modules can be used both inside and outside the building.
Przykładową konfigurację przedstawia poniższy schemat.
The monitoring center is located in an office building 1 . The CCTV system was created using the CDS-5IPmini devices. The signal from the office building 1A is sent to building 1.
The signal from the parking lot 2A, shopping center 2B, hospital 2C and clinics 2D, can not be transmitted directly to the monitoring center 1 because of signal blocking by office 2 (lack of sight).
The radio receiver Rx with the omnidirectional antenna is located on the building 2 and receives signals from the transmitters Tx on buildings 2A, 2B, 2C and 2D. The output from receiver Rx using a cable is hooked to a transmitter from which the signal is transmitted directly to the receiver Rx on the building 1.
The cameras on the court 3A, sports hall 3B and parking 3C is transmitted by transmitter (Tx) to the receiver (Rx) at the office 3. The receiver on the office 3 is connected by wire to the transmitter, which is located in the same building. The transmitter sends a signal to a receiver located in the monitoring center.
System uses camera power supply and UTP / FTP 10-20 m long. There is also the possibility to power the transmitter and the camera with one power supply 12-24 V DC (or 13.8 V buffer power supply). The use of PoE adapter allows you to avoid the use of expensive UPS and PoE power supply.
The device enables remote control and pre-view at selected tablets and smartphones.
- stable high-quality transmission of HD and UHD at 5 GHz,
- 1 W high power radio (30 dBi) - depend on used antennas,
- operates in configuration Point-to-Point and Point-to-Multipoint,
- OFDM radio modulation,
- The maximum speed of 300 Mbps radio transmission,
- transmission coding 64/128 / 152bit,
- CDS-5IP mini-SMA with R-SMA connectors to the external antenna,
- link testing tools,
- PoE 12-24V D C / 12W,
- LED radio signal level indicator,
- RF power control,
- works with all video resolutions - from VGA (640 x 480) through HD (1080p) to 4K UHD.
- transmission of video and audio from megapixel IP cameras HD and UHD,
- signal transmission from the IP recorders,
- signal transmission from analogue DVR with Ethernet output to other locations,
- transmitting audio / video in HD and UHD using any Ethernet / Internet networks,
- Bi-directional data transfer,
- IP PTZ cameras.